ZJ Grand Cherokee Roof Rack Platform System
To check shipping cost or purchase, please visit the ZJ Grand Cherokee Roof Rack Platform shopping cart page.
If you're considering a Roof Rack for your ZJ Jeep Grand Cherokee, but are concerned about the increased height that a typical roof rack requires, we have just the solution for you: Our new Hard-KOR Roof Rack Platform gives you a flat platform that mounts securely to your factory roof rails, and adds only 1.5 inches of increased height, allowing you to park in your garage, or in parking structures, with no problem at all. Here's some of the many benefits to the Hard-KOR Roof Rack Platform:
Mount some Rubbermaid containers on top, or lash them down with straps and a webbed cargo net for extra storage during long road trips with the family.
Toss your oversized spare tire on the roof, and get it out of the cargo area with the INCLUDED tire mounting plate and hardware.
Mount your roof-top tent (RTT) easily to the Roof Rack Platform, which allows it to be removed more easily than the permanent roof mounts.
Or, for a low-buck RTT option, pitch your current tent on top of the platform, keeping you off the ground, and away from critters.
Removable light bars are available as well, so you can add up to four lights across the front or rear (or both), which can be easily removed.
The entire Roof Rack Platform can be easily removed with 8 nuts, leaving the rail mounts in place, for easy mounting and dismounting
To check shipping cost or purchase, please visit the ZJ Grand Cherokee Roof Rack Platform shopping cart page.
To check shipping cost or purchase, please visit the ZJ Grand Cherokee Roof Rack Platform shopping cart page.
6 comments
We could make you one special, if you like. Just check out, and put that in the comments section, asking us to confirm before we ship, just to make sure. I have a batch of these being made next week, so now would be a perfect time to have a custom-built one made for you. I can either leave the moonroof area mesh flooring open, like our roof rack, and leave light tabs on the front…or I can make it shorter…either way you want.
Just to make sure, because I have not seen it specifically stated anywhere yet, this set up mounts directly to the roof rails and eliminates the need for the factory crossmembers correct?
Yessir…absolutely correct! I think we just sold our last one in stock, but it shouldn’t take more than a week or two to get another batch into production. :-)
Kevin